How big is a steel-tip dartboard?
The WDF specification used here gives a steel-tip bristle dartboard a nominal overall diameter of 451 mm (45.1 cm), with a ±3 mm manufacturing tolerance. The scoring circle is smaller: 340 mm across the outside double wires.
By Bigger vs · Published
Steel-tip dartboard measures 45.1 cm in diameter, about 2.1× the diameter of Soccer ball (22 cm).
- Soccer ball
- 22 cm (8.66 in)Steel-tip dartboard diameter is 2.05× this diameter · Diameter · Diameter through centre.
- A4 sheet of paper
- 29.7 cm (11.7 in)Steel-tip dartboard diameter is 1.52× this height · Height · A4 nominal long-edge height, not US Letter paper.
- Adult man
- 1.7 m (5.6 ft)Steel-tip dartboard diameter is 0.27× this height · Height · Ground under the feet to the crown of the head.
The outside edge gives the size answer
Measure across the circular board through its centre, from one outside edge to the opposite edge. Keep the surrounding wall protector and any cabinet out of that line. The selected drawing uses the 451 mm nominal body diameter. A circular target can look larger in a photograph when it includes a thick protective surround.
The scoring circle occupies only part of the face
The outside double-wire diameter is 340 mm in the same WDF edition, about 75% of the whole board’s diameter. The remaining face carries the outer margin and number ring. Our three scale comparisons use the outside body, so the illustrated scoring rings sit inside the answer rather than redefining it. Steel-tip boards and electronic soft-tip targets need their own specifications.
Compare the disc with a ball and a page
The adopted diameter is about twice the 22 cm soccer-ball example and about one and a half A4 long edges. A4’s 297 mm edge is a length, not the page’s diagonal. The standing-person view uses height as a third one-dimensional ruler. These ratios explain physical span; they say nothing about the area of the scoring sectors.
Measurement and sources
- Adopted measurement
- 45.1 cm (17.8 in) · Diameter
- Measurement basis
- Published measurement
- Scope
- Nominal overall bristle-board body diameter in this WDF specification, with the stated manufacturing tolerance. Surround, cabinet and wall hardware excluded.
- Measured endpoints
- Opposite outside board-body edges through the centre in a frontal view; not the 340 mm scoring circle.
- Source edition and location
- Playing and Tournament Rules, twentieth revised edition, 2018-02-28, Rule 4.01 Printed page 6: overall board 451.0 mm ±3.0 mm; 451 mm / 1000 = 0.451 m. Outside double-wire diameter 340.0 mm ±0.5 mm.
Read the complete measurement record · Inspect the illustration and measuring line · Open standalone SVG scale diagram
Source record checked . Guide reviewed .
Does 451 mm describe the double ring?
No. It describes the nominal overall board body. This WDF edition specifies 340 mm across the outside double wires, with its own tolerance. The two diameters should remain separate.